| Creating a preview [message #569] |
Wed, 13 April 2016 11:28  |
 witcom
Messages: 1
Registered: March 2007 |
Junior Member |
|
|
Hi,
Is it possible to create a preview of a movie, like the first 15 secs. of a movie ?
I tried Output/Mode/Multiply and rhen Use split but this splits the hole movie into 15 sec. chunks.
|
|
|
| Re: Creating a preview [message #572 is a reply to message #569 ] |
Fri, 15 April 2016 11:04  |
Videocharge Support
Messages: 363
Registered: December 2005
Location: USA |
Senior Member |
|
|
| witcom wrote on Sat, 14 April 2007 07:28 |
Hi,
Is it possible to create a preview of a movie, like the first 15 secs. of a movie ?
I tried Output/Mode/Multiply and rhen Use split but this splits the hole movie into 15 sec. chunks.
|
Two ways can be recommended here:
- Create new config file, add video file, go to the Editor. Here mark the first 15 seconds of video file, close the Editor, set Output -> Mode = Single. Perform other necessary settings and save the config file. Now you may run VideoCharge with saved config file via command line.
- Make use of File->Add folder's contents command. It's better choice if all your movies are in the same folder. Create new config file, add folder, set file mask, enable processing of subfolders if necessary, click OK. Now go to the Editor, mark the first 15 seconds of video file, close the Editor. Set Output -> Mode = Multiply, specify Destination Folder. Perform other necessary settings and save the config file. Click 'Run' - 15 sec. clip will be cut of all every file inside the selected folder.
[Updated on: Mon, 16 April 2007 11:06]
|
|
|
Members
Search
FAQ
Register
Login
Home
