Home
Download
Purchase
Forum
Site Map
F.A.Q.
Support
About Us
Home » VideoCharge » VideoCharge Support » capturing images from video files
capturing images from video files [message #174] Sun, 29 March 2015 22:30 Go to next message
satyaravind  is currently offline satyaravind
Messages: 2
Registered: March 2006
Location: lawrence
Junior Member
I would like to know if it is possible to capture images from entire video with user specified frame or time intervals.
Re: capturing images from video files [message #175 is a reply to message #174 ] Mon, 30 March 2015 09:49 Go to previous message
Videocharge Support  is currently offline Videocharge Support
Messages: 363
Registered: December 2005
Location: USA
Senior Member
satyaravind wrote on Wed, 29 March 2006 17:30

I would like to know if it is possible to capture images from entire video with user specified frame or time intervals.

Yes, it's possible. And we've made a decision to publish here a full-length instruction on creation of thumbnails Smile

You may create thumbnails in the following ways:

I.
  1. Turn on the “Thumbnails” check-box in the “Output” section
  2. Click on the “…” button to the right of the “Thumbnails” check-box
  3. Click on the “Insert New” button
  4. Set options for the thumbnail (here please pay your attention to “Frame for Thumbnail” option in the “Common” section – here you can specify the frame out of which you wish the thumbnail to be created)
  5. (repeat steps 3-4 if you need to create more then one thumbnail)
  6. Click “OK” button and run VideoCharge.
II.
  1. Open the Editor
  2. Select the required frame using the preview scroll-bar below.
  3. Open the “Edit” menu and select “Add Thumb” menu item (or press F3, or click on button on the left of the scroll-bar)
  4. (repeat steps 2-3 if you need to create more then one thumbnail)
  5. Close the Editor and run VideoCharge.
Using this methods you’ll get thumbnails as well as a video file or a picture at the output (depending on the specified output format)

index.php?t=getfile&id=23&private=0

Using the first method you can’t avoid creating an additional file (picture or video).
Using the second method you can avoid it, just turn on the “Thumb Only” check-box in the “Output” section.

III.

This method may be used in order to automatize creation of thumbnails. E.g. you need to create a thumbnail in every 10 seconds:
  1. In the output format list (see screenshot above) select the required graphic one (bmp, …, tiff)
  2. Turn on the “Use split” check-box in the “Output” section
  3. Select “Split by Time” mode
  4. Specify “Length” = 10 sec
  5. (Disable “Thumb Only” if enabled) Run VideoCharge.

See also:

Grabbing an image
Thumbnails per percentage of video

  • Attachment: Clip.gif
    (Size: 10.40KB, Downloaded 2614 time(s))

[Updated on: Thu, 30 March 2006 09:59]

Previous Topic:question about videocharge full
Next Topic:DEMO WATERMARK STILL THERE
Go to Forum:
  


Current Time: Fri Oct 18 22:22:40 UTC 2024

Total time taken to generate the page: 0.00533 seconds
.:: Contact :: Main site ::.